- Nyuair Hand Dryer wall mount kit
- A screwdriver
- A spirit level
- An electric drill
- A pencil
- Nyuair Hand Dryer wall mount kit
- A screwdriver
- A spirit level
- An electric drill
- A pencil
Make sure the hand dryer be positioned at least 20cm away from any objects and reflecting obstacles.
Use a spirit level, place the bracket and pre-mark where you want to be drilling those three holes.
Drill the wall where you just marked as mounting holes.
Put the bracket plate in line with the dots and insert the expansion tubes and screws to fully secure the bracket to the wall.
Simply clip the hand dryer into the bracket as shown in the image.
Using your screwdriver, secure the hand dryer to the bracket.
- Nyuair Hand Dryer wall mount kit
- A screwdriver
- A spirit level
- A pencil
Make sure the hand dryer be positioned at least 20cm away from any objects and reflecting obstacles. Use a spirit level. Use a pencil to lightly draw a straight line across the wall where you ‘ll want the back bracket plate to go. Clean the mounting surface.
Apply an even coat of glue (included in the kit) on the back of the bracket.
Tap a couple painter’s tape (included in the kit) tape onto the face of the bracket. Tape the bracket in place until the glue is set.
Allow 72 hours for the glue to fully cure. Remove the painter’s tape.
Simply clip the hand dryer into the bracket as shown in the image.
Using your screwdriver, secure the hand dryer to the bracket.
- Nyuair Hand Dryer stand kit
- A screwdriver
Each bracket has three holes. Two at the top, one at the bottom.
Screw the bracket into the stand. Bottom hole first, top two holes afterwards.
Simply clip the hand dryer into the bracket as shown in the image.
Using your screwdriver, secure the hand dryer to the bracket, which has been attached to the stand already.
Place the hand dryer upon the table or any flat top surface surface. Make sure the hand dryer be positioned at least 20cm away from any objects and reflecting obstacles.